Not a Current Stock Product
Please contact our team for assistance.
Pressure-sensitive adhesives
Paper
FSC ScandTherm NTC / SSP E60
Datasheet
Facestock
Scandtherm NTC is a white, woodfree paper, with black imaging thermosensitive coating designed for short term use in relatively clean and dry environments, where there are no requirements for surface protection against contaminants or scuffing. It can be printed with all commonly used technologies for roll converting, including water and uv-based flexo, uv letterpress etc., if inks and varnishes designed for direct thermal paper is used. We recommend customers to assess both pre-print and thermal print characteristics under end-use conditions before proceeding to long runs.
Type
Paper
| Properties | Value |
|---|---|
| Basis Weight | 46 lbs/rm |
| Caliper | 3.0 Mil |
Regulatory Approval
RoHS
Yes
Prop65
Yes
REACH
Yes
TPCH
Yes
CPSIA
Yes
UL
No
FSC
Yes
*Please contact your sales representative for details
Adhesive
ScandStick SSP E60 is a highly versatile permanent adhesive which will adhere to a wide variety of surfaces, both at room temperature and under chill conditions. SSP E60 has been designed to resist edge lift on narrow radius tubes and curved surfaces. SSP E60 has excellent conversion characteristics ensuring consistent waste stripping and label dispensing. It is also suitable for on-press delamination to allow printing on the adhesive surface or tack neutralisation. Although SSP E60 will tolerate some surface condensation, excessive amount of moisture present will reduce the adhesion.
Type
Permanent
Min. Application Temperature
5 F
Min. Service Temperature
-20 F
Max. Application Temperature
100 F
| Properties | Value |
|---|---|
| Stainless Steel | 13N |
Regulatory Approval
Direct Food
Yes
Indirect Food
Yes
Food contact
Meets composition requirement of indirect food additives regulation FDA175.105, BfR XIV.
FDA 21 CFR 175.105, BfR XIV
Yes
ISEGA approved for direct contact with dry and moist non-fatty foods
Yes
*Please contact your sales representative for details
WARRANTY: All data obtained through ASTM standards and are typical and should not be used for specification purposes. Because of the variety of possible uses, the buyer should test the suitability of each intended use. The buyer assumes all risks in connection with such use. BEONTAG will not be liable for damages in excess of the purchase price of Products or for incidental or consequential damages.
BEONTAG warrants the products to be free from defects in material and workmanship. Should any failure to conform to this warranty appear within one year after the initial date of shipment (unless otherwise stated), BEONTAG shall, upon notification thereof and substantiation that the products have been stored and applied in accordance with BEONTAG'S standards, correct such defects by suitable repair or replacement without charge at BEONTAG's plant or at the location of the products (at BEONTAG's election); provided, however, if BEONTAG determines that repair or replacement is not commercially practical, BEONTAG shall issue a credit in favor of BUYER in an amount not to exceed the purchase price of the products
Address:
Beontag
6206 Wolf Creek Pike
Trotwood, OH 45426
800-358-4448
orders.us@beontag.com