Not a Current Stock Product
Please contact our team for assistance.
Self adhesives
Hotmelt Ru
Paper
FSC ScandTherm NTC / SSP 50N
Datasheet
Facestock
Scandtherm NTC is a white, woodfree paper, with black imaging thermosensitive coating designed for short term use in relatively clean and dry environments, where there are no requirements for surface protection against contaminants or scuffing. It can be printed with all commonly used technologies for roll converting, including water and uv-based flexo, uv letterpress etc., if inks and varnishes designed for direct thermal paper is used. We recommend customers to assess both pre-print and thermal print characteristics under end-use conditions before proceeding to long runs.
Type
Paper
| Properties | Value |
|---|---|
| Basis Weight | 46 lbs/rm |
| Caliper | 3.0 Mil |
Regulatory Approval
RoHS
Yes
Prop65
Yes
REACH
Yes
TPCH
Yes
CPSIA
Yes
UL
No
FSC
Yes
Adhesive
General purpose, strong permanent adhesive with good chill characteristics. ScandStick Permanent 50N has excellent initial tack with high bond strength at elevated, room and chilled temperatures, as well as in moist conditions. It has been formulated to adhere to a wide variety of substrates, including corrugated cardboard, low surface energy materials like polyethylene and non-polar surfaces. SSP 50N provides enhanced conversion characteristics, allowing die-cutting at higher speeds and is designed for both paper and synthetic face materials. Limitation: Not suitable for labelling plasticized
Type
Perm
| Properties | Value |
|---|---|
| Typical Peel Adhesion | 0lbs/linear in. |
| Polyethylene | 0 |
Regulatory Approval
RoHS
Yes
Prop65
Yes
REACH
Yes
TPCH
Yes
CPSIA
Yes
UL
No
Direct Food
No
Indirect Food
Yes
WARRANTY: All data obtained through ASTM standards and are typical and should not be used for specification purposes. Because of the variety of possible uses, the buyer should test the suitability of each intended use. The buyer assumes all risks in connection with such use. BEONTAG will not be liable for damages in excess of the purchase price of Products or for incidental or consequential damages.
BEONTAG warrants the products to be free from defects in material and workmanship. Should any failure to conform to this warranty appear within one year after the initial date of shipment (unless otherwise stated), BEONTAG shall, upon notification thereof and substantiation that the products have been stored and applied in accordance with BEONTAG'S standards, correct such defects by suitable repair or replacement without charge at BEONTAG's plant or at the location of the products (at BEONTAG's election); provided, however, if BEONTAG determines that repair or replacement is not commercially practical, BEONTAG shall issue a credit in favor of BUYER in an amount not to exceed the purchase price of the products.
Address:
Beontag
Pål Anders väg 4, 263 35
Höganäs, Sweden
+46 42 25 00 50
orders.scandstick@beontag.com